Section 2: Installation And Equipment Setup; Connections - Honeywell HEGS5000 User Manual

INSTALLATION AND EQUIPMENT SETUP
2.1

CONNECTIONS

A terminal block is provided for connection between the HEGS5000 controller and
peripheral equipment. A coiled cable is provided for connection between the
HEGS5000 and the terminal block. Plug one end of the coiled cable into the connector
on the back of the HEGS5000 and the other end into the jack on the terminal block.
Power Supply
COM1 (RS485 output port)
COM2 (RS232 serial port)
Refer to Section 2.2 for installation diagrams for connection to Multiplexers, VCRs, etc.
Rev. 1.01
SECTION 2:
Description
Connect the power supply, part number 849193-0089,
provided with the unit.
Used for controlling Honeywell KD6/HD6 series domes.
Used for controlling Honeywell multiplexers and VCRs.
GND
+12VDC
RS-485 (D-) - COM1
RS-485 (D+) - COM1
3
RS-232 (TX) - COM2
RS-232 (RX) - COM2
900.0800
19-Jun-06