Setting Signals - Fujitsu Plasmavision PDS4208W-B Service Manual

SETTING SIGNALS

This display can store parameter settings for eight additional signals for RGB.
To do this, select the desired signal and follow "RGB MODE ADJUSTMENT" in the manual to adjust the parameters.
When you finish, the settings will be automatically stored.
This unit has been factory-set for the 18 signals shown below.
FACTORY SET SIGNALS (RGB MODE)
Display (dots x lines)
852 x 480 31.72
640 x 480 31.47
640 x 480 37.86
640 x 480 37.50
640 x 480 43.27
720 x 400 31.47
640 x 400 37.86
800 x 600 35.16
640 x 400 37.88
800 x 600 48.08
800 x 600 48.88
1,024 x 768 48.36
640 x 480 35.00
848 x 480 31.02
640 x 480 15.73
640 x 480 15.63
640 x 400 24.82
640 x 400 31.50
15.63 to 80.00*
" Out of range" appears if the dot clock of the input signal exceeds 54MHz (68MHz for XGA) even when the horizontal
and vertical frequencies are within their permissible ranges.
In this case, the sampling clock is fixed at 54MHz (68MHz for XGA).
Make sure that the vertical frequency of the input signal is 75Hz or less for SVGA and 60Hz for XGA.
Horizontal frequency (kHz) Vertical frequency (Hz)
59.97
59.94
72.81
75.00
85.01
70.09
85.08
56.25
60.32
72.19
75.00
60.00
66.67
60.00
59.94
50.00
56.42
70.15
50.00 to 120.00*
– 5 –
Signal
When a dedicated
graphics card used
VGA
VGA 72Hz
VGA 75Hz
VGA 85Hz
VGA 400 lines
VGA 400 lines
SVGA 56Hz
SVGA 60Hz
SVGA 72Hz
SVGA 75Hz
XGA 60Hz
MAC 13RGB
60 fields
50 fields
NEC 24kHz
NEC 31kHz
User setting