12. Removing the PDP unit
(1) Remove the Rear Case (Upper).
(2) Remove the Video PCB Unit.
(3) Remove the Frame Panel MID Upper and Lower.
- Remove the 7 screws.
(4) Remove the Temp. Sensor PCB .
(5) Remove the Power Cover.
(6) Remove the Duct fans (Right and Left), and
disconnect the connectors circled in the picture.
(7) Disconnect the connector to the Power Supply Unit
and inlet.
(8) Remove the Rear Case Lower.
Remove it together with the Main/Digital PCB,
Audio PCB and Noise Filter.
-Remove the 13 screws.
Noise filter: Disconnect the
black and white wires
– 40 –
View after Video PCB Unit and Rear Case Upper
removed
Duct fans
Main/Digital PCB: Disconnect the 68-pin
connector and other connectors
Remove this connector.
Screwed together with
Main/Digital PCB