2. Removing the Rear Case (Upper)
: This mark indicates the screw positions.
(1) Remove the 19 screws shown at the right.
3. Removing the Temp. Sensor PCB
(1) Remove the Rear Case (Upper).
(2) Remove the connector and screw.
View after Rear Case (Upper) removed
4. Removing the DC/DC Power PCB Assy
(1) Remove the Rear Case (Upper).
(2 Remove the insulation sheet on the DC/DC Power PCB.
(3) Remove the connectors and the 3 screws.
(Do not lose the screw assy.)
View after insulation sheet removed
– 31 –