Sanyo VCC-4594P Service Manual page 16

PRODUCT SAFETY NOTICE
PRODUCT SAFETY SHOULD BE CONSIDERED WHEN COMPO-
NENT REPLACEMENT IS MADE IN ANY AREA OF A UNIT COMPO-
NENTS INDICATED BY THE SYMBOL
GRAM SHOW COMPONENTS WHOSE VALUE HAVE SPECIAL SIG-
NIFICANCE TO PRODUCT SAFETY IT IS PARTICULARLY RECOM-
MENDED THAT ONLY PARTS SPECIFIED ON THE ATTACHED
PARTS LIST BE USED TO COMPONENTS REPLACE DESIGNATED
BY THE SYMBOL .
NOTE:
1. N.S.P. : Not available as service parts.
2. All resistance values in "OHMS" unless otherwise noted.
(K=1,000 ; M=1,000,000)
3. All inductance values in "µ µ µ µ µ H" unless otherwise noted.
µ µ µ µ µ , u or U=micro henry ;
4. All capacitance values in "µ µ µ µ µ F" unless otherwise noted.
µ µ µ µ µ , u or U=micro farad
p=pico farad ;
5. Voltage reading may vary
6. This is a fundamental circuit diagram, some production
changes may be made without revision of the diagram.
EXPLANATORY NOTES (EXAMPLES)
Resistor 10K:1/16J means 10kilo ohm
1M:1/10K means 1mega ohm
Capacitor 0.047:F means 0.047micro farad, Ftype.
Electrolytic capacitor
10:16 means 10micro farad, 16volt max.
Inductor 330:J means 330micro henry
470:K means 470micro henry
No description J or K means
IN THIS SCHEMATIC DIA-
m=milli henry
±
20%.
±
5%, 1/16watt max.
±
10%, 1/10watt max.
±
5%
±
10%
±
5%
NA_C_EX