Removing Procedure - Kenwood DNX7180 Quick Start Manual

Quick Start Guide
~I::'~II
I.
the microphone as far as po,ssible
from the cell-phone.
.

Removing Procedure

Removing the hard rubber
frame (escutcheon)
Engage the catch pins on the
1)
removal tool (accessory(1)) and
remove the two locks on the
lower level.
Lower the frame and pull it
forward as shown in the figure.
NOTE
• The frame can be
side in the same manner.
2) When the lower level is removed,
remove the upper two locations.
'-,----,
removed
from the top
-26-
Removing the unit
Remove the hard rubber frame by
1)
step
referring to
the hard rubber frame".
2) Insert the two removal tools
(accessory@)) deeply into the slots
on each side, as shown.
3) Lower the removal tool toward
the bottom, and pull out the unit
halfway while pressing towards
the inside.
'
--'------""_·--'·-1
r-
,~_.~-_._-._---,----'
I
NOTE
.
Be careful to avoid injury from the catch
I
pins on the removal tool.
l
4) Pull the unit all the way out with
your hands, being careful not to
drop it.
in "Removing
1
I
I
I
,