Advertisement
Displaying Fixture Information
The UTIL menu lets you display information about the fixture, including firmware
versions, fixture serial number, current operating temperature, and current voltage
consumption.
To display fixture information:
►
1.
Select UTIL > INFO.
2.
Do one of the following:
To display the firmware version of the main LED board, select VER > MAIN.
▪
To display the firmware version of the menus (user interface), select VER >
▪
UI.
To display the fixture's serial number, select S/N. The eight-digit serial
▪
number scrolls continuously across the four-character readout area until the
menu times out.
To display the fixture's current internal operating temperature, select TEMP.
▪
The operating temperature, in degrees C followed by degrees F, scrolls
across the readout area until the menu times out.
To display the fixture's current input voltage, select VOLT.
▪
Saving and Loading Profiles
You can save a fixture's current settings to one of two profiles, then load the saved
profile to reapply the settings. Profiles can save you time if you often configure
ColorBlast TRX fixtures in a similar manner for different applications, or if you often
switch between the same two configurations. You can load the default profile at any
time to restore the fixture's initial factory settings.
To save the fixture's current settings to a profile:
►
1.
Configure the fixture however you wish.
2.
Select UTIL > PROF > SAVE.
3.
Select 1 or 2.
4.
Press Enter to confirm.
To load a saved profile:
►
1.
Select UTIL > PROF > LOAD.
2.
Select 1 or 2.
3.
Press Enter to confirm.
To restore a fixture's initial factory settings:
►
1.
Select UTIL > PROF > LOAD.
2.
Select DFLT.
3.
Select Restore Defaults?, then Yes?.
4.
Press Enter to confirm.
20
ColorBlast TRX
Product Guide
Advertisement
