Advertisement
Attach Safety Cable
Each ColorBlast TRX fixture is designed for use with a safety cable to tether it to a
secure anchor point. When dictated by local or state code or advised by a structural
engineer, attach a safety cable to the bracket on the back of the fixture using a
standard carabiner clip. Attach the safety cable to the mounting surface using a
method that follows the code or engineer's requirements.
Aim and Lock the Fixtures
Using the included 3/32 in hex key wrench, loosen the tilting set screws located
on the front of the fixture's mounting base. Aim the fixture by tilting the beam as
desired. Optionally tighten the set screws to lock the fixture in place.
14
ColorBlast TRX
Product Guide
(Optional)
3/32 in
130°
Safety cable minimum requirements
Material
316 Stainless Steel
5/64 to 3/16 in (2 to 5 mm) nominal
Size
diameter. Minimum break load must be
greater than 400 lbs (181 kg)
Construction
7 x 7 (49 wires) preformed stranded
Advertisement
