Lenovo 10AX User Manual page 66

5. Remove the two screws that secure the hard disk drive assembly. Slide the hard disk drive assembly as
shown, and then lift the hard disk drive assembly to remove it from the computer.
Figure 40. Removing the hard disk drive assembly
To install the hard disk drive assembly, do the following:
1. Position the hard disk drive assembly on the system board so that the two holes in the hard disk drive
bracket are aligned with the standoffs on the system board. Slide the hard disk drive assembly as shown
until the two screw holes
Figure 41. Installing the hard disk drive assembly
54
ThinkCentre M73 User Guide
1 are aligned with the corresponding screw posts on the system board.