Configure Installer Setup - Honeywell TH5110D Installation Instructions Manual

INSTALLER SETUP

Configure Installer Setup

1. Enter Installer Setup by pressing and holding the
Up and Fan buttons, at the same time, for
approximately five seconds, until the screen
changes. See Fig. 16.
Replace Batt
Inside
Service Needed
Fan System
Auto
Fig. 16. Enter Installer setup.
2. Release the Up and Fan buttons when the
display on the thermostat matches the display
in Fig. 17.
Cool
Setting
Cool
M22079
TH5110D NON-PROGRAMMABLE THERMOSTAT
Replace Batt
Service Needed
Done
Fig. 17. Configure Installer Setup.
3. See Fig. 18 to review how the thermostat buttons
are used during Installer Setup. See Table 3 for the
Installer Setup Numbers and Settings.
INSTALLER SETUP
NUMBER
DONE BUTTON
EXITS THE
INSTALLER SETUP
AND SAVES YOUR SETTINGS
Fig. 18. Review thermostat buttons used for Installer
7
Next
M22143
SETTING
UP BUTTON
CHANGES SETTING
Replace Batt
DOWN BUTTON
Service Needed
CHANGES SETTING
Done Next
NEXT BUTTON
ADVANCES TO NEXT
INSTALLER SETUP
NUMBER
Setup.
M22144
69-1712—1