Backlight Unit, Lcd Panel - Canon PowerShot A100 Service Manual

CHAPTER 3. REPAIR INSTRUCTION
NOTE (Assembling)
(1)-1
Soldering
(1)-2
c

2.4 BACKLIGHT UNIT, LCD PANEL

(1) BACKLIGHT UNIT
1. Remove soldering at three locations.
NOTE (Assembling)
After soldering, apply the DIA BOND1663G.
2. Remove the four screws c.
3. Remove the BACKLIGHT UNIT.
NOTE (Assembling)
Align the two positioning dowels of the REAR COVER UNIT at each location.
(2) LCD PANEL
1. Release the six claws in the top, bottom, right and left, and remove the BACKLIGHT UNIT and LCD
PANEL.
NOTE (Assembling)
The BACKLIGHT supplied as the service part had the protection sheet. Remove it.
REAR COVER UNIT
(2)-1
Claws
(2)-1
(2)-1
Claws
(1)-2
c
(1)-3 BACKLIGHT UNIT
Fig. 3-6 BACKLIGHT UNIT, LCD PANEL
NOTE (Assembling)
Positioning when assembling
LCD PANEL
NOTE (Assembling)
3-6
c
XA4-9170-407
4.0mm
METAL
M1.7
(SELF TAP)