Operating - HearthSense ANI Manual

OPERATING INSTRUCTIONS
FOR YOUR SAFETY
READ BEFORE LIGHTING
WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing property
damage, personal injury or loss of life.
CAUTION: Do not try to adjust heating levels by using the equipment shutoff valve.
NOTICE: During initial operation of new heater, logs will give off a paper-burning smell. Orange flame will also
be present. Open a window to vent smell. This will only last a few hours.
A. This appliance is equipped with an ignition device which automatically lights the pilot. Do not try to light the pilot
by hand.
B. BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor because some
Gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
l Do not try to light any appliance.
l Do not touch any electrical switch; do not use any phone in your building.
l Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions.
l If you cannot reach your gas supplier, call the fire department.
C. Use only your hand to push controls. Never use tools. If the appliance does not operate, don't try to repair it,
Call a qualified service technician or gas supplier. Forced or attempted repair may result in a fire or explosion.
D. Do not use this appliance if any part has been under water. Immediately call a qualified service technician to
inspect the appliance and to replace any part of the control system and any gas control which has been under
water.
Function of Manual Power ON/OFF Switch
Note: To operate your heater the ON/OFF switch must be
in the ON position.
Figure 24-Opreating Control
17