Table of Contents
Advertisement
6.2.
Confirmation of Firmware Version
The Firmware version can be confirmed by ordering the following steps:.
• Step 1. The temporary cancellation of factory setting:
Set the mode dial to "[ Normal picture mode ] (Red camera mark)".
Insert the SD memory card which has a few photo data.
While keep pressing [ Optical Image Stabilizer ] and "[ UP ] of Cross key" simultaneously, then turn the power on.
• Step 2. Confirm the version:
Set the mode dial to "[ Playback ]" and then press [ DISPLAY ] to switch to LCD with indication. (Fig. A)
Press [ Optical Image Stabilizer ] and "[ DOWN ] of Cross key" simultaneously. (No need to keep pressing.)
(The version information is displayed on the LCD with light blue colour letters.) (Fig. B)
CAUTION:
The version information does not display if the LCD has switched to LCD with indication already.
In this case, press [ DISPLAY ] to switch to LCD with indication.
<Point>
• The firmware version and EEPROM version can be confirmed with the information (1).
• The information (2), (3) are just reference.
17
Advertisement
Chapters
Table of Contents
