Input Setup; Hdmllnassign - Denon AVR-1709 Owner's Manual

ENGLISH
Test Tone Start
Press <l to select "Yes", then press
"Manual".
Then press 'V. Out put the test tone.
<l I>
Auto : Press to adjust the volume.
Manual: Press f:" 'V to select the speaker, then press
the volume.
When the adjustments are completed, press ENTER to finish the test
tone.
I
-12dB -
[Variable range]
%
Operating from the main remote control unit
Adjusting with the main remote control unit using the test tones is
only possible in the "Auto" mode and only effective in the STANOARO
mode. The adjusted levels for the different modes are automatically
stored in the memory.
[Adjusting using test tones]
CD
Press [TESn.
Test tones are output from the various speakers.
(1) Use <ll> to adjust so that the volume is equal for all speakers.
®
When the adjustments are completed, press [TESn.
-When "System Setup" - "Speaker Setup" - "Surround Back
Speaker" setting (~page 23) is set to "lspkr", the surround back
speaker display is "SB".
- Speakers set to "None" in the Speaker Configuration settings are
not displayed.
- When "Channel Level" is adjusted, the adjusted values are set for all
the surround modes.
I
25
For details on how to select, set and cancel settings for each menu, see "System setup operation" l(jT'page
PI
<l I>
to select "Auto" or
After the Auto Setup measurements, it is possible to return those
settings to the Auto Setup measurement results after changing
the speaker settings (speaker configuration, distance, channel
level and crossover frequency) with "System Setup" - "Speaker
Setup".
<ll>
to adjust
Press
[Display]
I I-
OdB +12dB
It is not possible to return to Amp Assign settings with Restore.
After running Auto Setup, if the Amp Assign setting has changed,
return to the setting when Auto Setup was run.
Restore
<l to start.
1r-.-.-
. -c-,
- -.- -r'-,-:-,
- F -'- -
S 2 I
P
2.

Input Setup

Use this procedure to select the Input source and make the settings
related to playing input sources.
0-10
HDMlln Assign
II-D
Digital In Assign
II
iPodAssign
m-m
Component In Assign
1m-1m
Video Convert
1m
Audio Delay
II
EXT. IN Subwoofer Level
1m
Auto Preset Memory
1m
Parental Lock
Pm
Edit Lock Code
• - II
HOMI In Assign
Select HOM I connector to assign to this source.
[Display]
I-r'"- -
- - . - .
1.SF' :;.C!F
1
I SetuF
nF'ui:
HDI'1 I 1 DUC'
2 HC'f'i I 2 H.I
HOMI1 HDMI2 HOMI3
[Input terminals]
[Assignable input sources]
I II
1* TV/cBll* 21
11
OVD/HDP VCR V.AUX
*
1 : "OVO" is displayed.
*
2 : "TV" is displayed.
0
Input tenninals
HDMI1
Default setting
DVD/HDP
•
• With HOM!. the video and audio
simultaneously. (The HOM I audio signal is output from the monitor.)
At this time, set the input mode to "Auto".
• The audio signals input from the analog, digital and EXT. IN connectors
are not output to the monitor.
22).
II I
OFF
If) 10
HDMI2 HDMI3
TV/CBL VCR
signals are transferred