Table of Contents
Advertisement
16 Initial use
devolo Vianect AIR TV
Observe the setup instructions listed in
the previous section. (see 3.4 Setup in-
structions)
To connect the Vianect AIR TV station to a TV set
or projector via HDMI, connect both devices via
an HDMI cable; digital image and sound data
are transmitted via the HDMI cable simultane-
ously.
or
To connect the Vianect AIR TV station to a TV set
or projector via VGA (image transmission), con-
nect both devices via a VGA cable. For sound
transmission, connect the 3.5 mm jack sock-
ets of the devices (TV set, projector or stereo sys-
tem) via a cable with 3.5 mm jack plug.
If the sound transmission does not work au-
tomatically after complete and correct instal-
lation of the hardware and software, in the
sounds and audio devices properties, under
Audio select as the default device for sound
playback USB PnP Sound device. For more
detailed help on verifying the settings, refer
to our online FAQs on our website at
www.devolo.com.
If you want to connect additional TV sets or pro-
jectors, simply repeat steps
device.
3.7 Restoring the pairing
To again configure the devices, proceed as follows:
If you have not done so already, install the pro-
vided devolo software on your computer. (see
Chapter 3.5 Software installation)
Then insert the computer adapter into an availa-
ble USB socket of your computer.
Remove the computer adapter and, in its place,
plug the TV adapter into the now available USB
socket of your computer. After a few seconds, a
message appears stating that the pairing is
completed.
to
for each
Advertisement
Table of Contents
