Installation Manual For Dealers - Sony PFM-500A3WE Service Manual

4-074-892-01 (1)
Input Adaptor
Installation Manual for
Dealers
BKM-500
Sony Corporation ©1999 Printed in Japan
A
1
Right side of the
monitor
1
B
1
2
1
C
3
2
3
English
Follow the steps below to install the Input Adaptor to the
PFM-500A/510A series Flat Panel Monitors.
Installing the Input Adaptor (Figures
A , B and C )
Before installation
• Before installation, make sure that the power to all the
equipment is off. To turn the monitor completely off, press
the 1 switch so that the monitor changes to standby mode,
then disconnect the power cable from the wall outlet.
• If the monitor has been installed on a wall, remove it from
the wall.
• If you are using the SS-X500A Speaker System, remove
the right speaker.
• Install the Input Adaptor to the monitor on a stable, flat and
horizontal surface. Lock the monitor by using the
retractable feet.
1
On the right side of the monitor, locate the screws that
lock the panel cover on the monitor. Loosen the screws
by turning them counterclockwise and open the cover.
A
If another connector panel has been installed on the
monitor, remove the connector panel as follows:
1 Loosen the two screws that are at the top and bottom
of the right connector panel.
You can now remove the connector panel. B
2 Slowly pull out the connector panel from the
monitor. B
2
First make sure that the direction (top/bottom) of the
Input Adaptor, then correct and insert it into the monitor.
Make sure that the two connectors inside the monitor are
connected firmly. C
3
Tighten the top and the bottom screws. C
4
Connect the required cables. Close the panel cover
(opened in Step 1) and lock it with the cover screws.
Caution
Do not touch the connectors in the monitor. Doing so may
be result in injury to yourself or damage to the connectors.