Electrical Adjustments - Sony HCD-GTR6 Service Manual

HCD-GTR6/GTR6B/GTR7/GTR8/GTR8B
0 dB = 1 µV
TUNER SECTION
[FM Tune Level Check]
SET
Procedure:
1. Turn the power on.
2. Input the following signal from Signal Generator to FM an-
tenna input directly.
* Carrier Freq : A = 87.5 MHz, B = 98 MHz, C = 108 MHz
Deviation : 75 kHz
Modulation : 1 kHz
ANT input : 35 dBu (EMF)
Note: Please use 75 ohm "coaxial cable" to connect SG and the set. You
cannot use video cable for checking.
Please use SG whose output impedance is 75 ohm.
3. Set to FM tuner function and tune A, B and C signals.
4. Confi rm "TUNED" is lit on the display for A, B and C sig-
nals.
The mark of "TUNED" means "The selected station signal is
received in good condition."
20
SECTION 4

ELECTRICAL ADJUSTMENTS

DECK SECTION
(only for HCD-GTR6B/GTR8B)
FM signal generator
1. Demagnetize the record/playback head with a head
2. Do not use a magnetized screwdriver for the adjustments.
OUT (75 )
3. After the adjustments, apply suitable locking compound to the
4. The adjustments should be performed with the rated power
5. The adjustments should be performed in the order given in this
6. The adjustments should be performed for both L-CH and R-
7. Switches and controls should be set as follows unless otherwise
[RECORD/PLAYBACK HEAD AZIMUTH
ADJUST-MENT]
Note: Perform this adjustments for Single deck
Procedure:
1. Mode: Playback
2. Turn the adjustment screw and check output peaks. If the peaks
0 dB = 0.775 V
demagnetizer.
parts adjust.
supply voltage unless otherwise noted.
service manual. (As a general rule, playback circuit adjust-
ment should be completed before performing recording circuit
adjustment.)
CH.
specifi ed.
• Test Tape
Tape Signal
P-4-A100 10 kHz, –10 dB
(L-CH & R-CH)
test tape
P-4-A100
(10 kHz, –10 dB)
set
do not match for L-CH and R-CH, turn the adjustment screw
so that outputs match within 1dB of peak.
within
L-CH
1dB
peak
output
level
R-CH
peak
screw
position
L-CH
peak
Used for
Azimuth Adjustment
level meter
+
–
within
1dB
screw
position
R-CH
peak