Step 2: Insert The Batteries Into The Remote; Step 3: Preset The Channels Automatically - Sony TRINITRON KV-AR25M81A Service Manual

Notes
• If you connect a monaural VCR, connect the yellow plug to
• If you connect a VCR to the 8 (antenna input) terminal, preset the signal output
• If both
• Do not connect video equipment to the t 2 (video input) jacks at the front and the
• When no signal is input from the connected video equipment, the TV screen
CAUTION
• Do not plug in the power cord until you have completed making all other
• To avoid battery leakage and damage to the remote, remove the batteries from
Step 2
Insert the batteries
into the remote
Note
• Do not use old batteries nor use different types of batteries together.
Step 3
Preset the channels automatically
Front of TV
ENTER SELECT
L(MONO) R
AUTO
2 SELECT PROGR PROGR
Tips
• If you want to stop automatic channel presetting, press SELECT twice.
• If your TV has preset an unwanted channel or cannot preset a particular
Note
• During automatic channel presetting, your TV screen will indicate "B/G" ,
and the black plug to -L (MONO) (the white jack).
from the VCR to the program number 0 on the TV.
(S video input) and t 1 (video input) at the rear of your TV are input
at the same time, the
video input to t 1 (video input), disconnect the S video cable.
rear of your TV at the same time; otherwise the picture will not be displayed
properly on the screen.
becomes blue.
connections; otherwise a minimum leakage current might flow through the
antenna and other terminals to ground.
the remote if you are not going to use it for several days. If any liquid that leaks
from the batteries touches you, immediately wash it away with water.
1
2
AUTO
PROGR
channel, then preset your TV manually (see page 10).
"I", "D/K" or "M" for the TV system ("TV SYS").
(S video input) is automatically selected. To view the
1
VHF LOW B/G
(the yellow jack)
1
Using Your New TV
5