Table of Contents
Advertisement
CBA750B | USER MANUAL Firmware version 4.2
CRADLEPOINT
DHCP:
Changing settings for the DHCP server is optional. The default selections are almost always sufficient.
DHCP Server: (Default: Enabled) When the DHCP server is enabled, users of your network will be able to automatically
connect to the Internet without any special configuration. It is recommended that you leave this enabled. Disabling the
DHCP server is only recommended if you have another DHCP server on your network and it is configured properly.
Range Start and Range End: These designate the range
of values in the reserved pool of IP addresses for the
DHCP server. Values within this range will be given to any
DHCP enabled computers on your network. The default
values are almost always sufficient (default: 72 to 200, as
in 192.168.0.72 to 192.168.0.200).
Example: The CBA750B uses an IP address of 192.168.0.1 for its
primary network by default. A computer designated as a Web server
has a static IP address of 192.168.0.3. Another computer is designated
as an FTP server with a static IP address of 192.168.0.4. The starting
IP address for the DHCP server needs to be 192.168.0.5 or higher.
Lease Time: [Default: 720 minutes (12 hours)] The lease
time specifies how long DHCP-enabled computers will wait
before requesting a new DHCP lease. Smaller values are
better suited to busy environments.
© 2013 CRADLEPOINT, INC.
PLEASE VISIT
HTTP://KNOWLEDGEBASE.CRADLEPOINT.COM/
FOR MORE HELP AND RESOURCES
PAGE 72
Advertisement
Table of Contents
