Table of Contents
Advertisement
CBA750B | USER MANUAL Firmware version 4.2
CRADLEPOINT
6.5.1
Local IP Networks
Local IP Networks displays the following information for each network:
• Network Name and IP address/Netmask (along the top bar)
• Enabled (Yes/No)
• DHCP Mode (e.g. DHCP Server mode)
• Schedule (Enabled/Disabled – See the
Schedule tab in the Local Network
Editor)
• Routing Mode (NAT, Standard, IP
Passthrough, Disabled)
• Access Control (Admin Access, UPnP
Gateway, LAN Isolation)
• Attached Interfaces (Ethernet port, VLAN)
Click Add to configure a new network, or select an existing network and click Edit to view configuration options.
6.5.2
Local Network Editor
The Local Network Editor contains the following tabs: IP Settings, Interfaces, Access Control, DHCP Server and
Schedule.
IP Settings:
Name: This primarily helps to identify this network during other administration tasks.
Hostname: [Default: cp (for CradlePoint)] The hostname is the DNS name associated with the router's local area network
IP address.
NOTE: You can access the router's administration pages by typing the hostname into your browser, so if you change "cp" to another hostname,
you can access the administration pages through the new hostname.
IP Address: This is the address used by the router for local area network communication. Changes to this parameter may
require a restart to computers on this network.
© 2013 CRADLEPOINT, INC.
PLEASE VISIT
HTTP://KNOWLEDGEBASE.CRADLEPOINT.COM/
FOR MORE HELP AND RESOURCES
PAGE 68
Advertisement
Table of Contents
