Thermostat Information - Honeywell Chronotherm IV T8602C Installation Instructions Manual

T8602C CHRONOTHERM
Refer to Table 5 for the directions and results of the
specific tests.
Key to Test
Press Number
Heating Equipment System Test
Time 10
11
10
Cooling Equipment System Test
Time 30
31
30
Fan Equipment System Test
Time 40
41
40
Key Operation System Test
Time
60 2
NOTE: Press any key and the displayed numbers will change. Press Time
to go to the next test. The Run Program key will not exit this test. Press Time
Run Program key to exit.

THERMOSTAT INFORMATION

1. Press the Time
information.
2. Press the increase s key to display the production
date code. The first two large digits are the month
and the third digit is the last digit of the year
(Example: 027 = February 1997).
3. Press the increase
software identification code. (Example: 02 =
software ID code 2)
69-1567
®
IV DELUXE PROGRAMMABLE THERMOSTATS
Table 5. Installer System Test Options.
Enter heating equipment system test.
Heat comes on. When Installer Setup number 2 is 1, the system fan is also energized.
Heat and system fan turn off.
Change from heating to cooling equipment system test.
Cool and system fan come on.
Cool and system fan turn off.
Change from cooling to fan equipment system test.
Fan comes on.
Fan turns off.
Change from fan to key operation system test.
key to access the thermostat
key again to display the
NOTE: Press Time
Time
Run Program to exit the system test.
Description
4. Press the increase
software revision number (Example: 001 =
Revision number 1).
M14613
5. Press the increase
EEPROM identification code. (Example: 314 =
EEPROM ID 314)
M14614
6. Press the Run Program key to exit the system
test. The system test times out after four minutes
without any key presses.
M14615
8
to advance to the next test and
to go back to the previous test. Press
to go to the previous test and Time
or Time and then the
key again to display the
key again to display the
M14616
M14617