Connecting The Fm Antenna - Samsung HT-D550K User Manual

Connections
HDMI FUNCTION
HDMI Auto Detection Function
If your TV is Samsung TV and it supports CEC function.The product's video output will automatically change to HDMI
mode when connecting an HDMI cable while power is on.
~ HDMI (High Defi nition Multimedia Interface)
HDMI is an interface that enables the digital transmission of video and audio data with just a single
~
connector. Using HDMI, the product transmits a digital video and audio signal and displays a vivid picture
on a TV having an HDMI input jack.
HDMI connection description
~
- HDMI outputs only a pure digital signal to the TV.
- If your TV does not support HDCP (High-bandwidth Digital Content Protection), random noise appears
on the screen.
~ What is the HDCP?
HDCP (High-band width Digital Content Protection) is a system for protecting DVD content outputted via
~
HDMI from being copied. It provides a secure digital link between a video source (PC, DVD. etc) and a
display device (TV, projector. etc). Content is encrypted at the source device to prevent unauthorized
copies from being made.
Using Anynet+(HDMI-CEC)
Anynet+ is a function that enables you to control other Samsung Devices with your Samsung TV's remote
control. Anynet + can be used by connecting this product to a SAMSUNG TV using a HDMI Cable. This is
only available with SAMSUNG TV's that support Anynet+.
1. Connect the product to a Samsung TV with an HDMI cable. (See page 21)
2. Set the Anynet+ function on your TV. (See the TV instruction manual for more information.)
✎
NOTE
`
The Anynet+ function supports some buttons of the remote control.
`
This function is not available if an HDMI cable does not support CEC.
`
Depending on your TV, certain HDMI output resolutions may not work.
Please refer to the user's manual of your TV.
`
Please check the
VIDEO
OUT
FA NET FA NET
WIRELESS HDMI OUT
(Only For Service) (Only For Service)
AUX COMPONENT COMPONENT
IN 2 OUT OUT

English
logo (If your TV has an

Connecting the fm Antenna

FM Antenna (supplied)
FM ANT
logo, then it supports Anynet+ function.)
1. Connect the FM antenna supplied to the FM Antenna
jack.
2. Slowly move the antenna wire around until you fi nd a
location where reception is good, then fasten it to a wall
or other rigid surface.
✎
NOTE
`
This product does not receive AM broadcasts.