Yamaha MG 166CX-USB Service Manual page 18

MG166CX-USB/MG166CX/MG166C-USB/MG166C
2-3. MG166CX-USB, MG166CX
Connect the ten (10) jumper wires of JACK16X circuit board to the MIX16X circuit board. (MG166CX-USB, MG166CX)
Note: Bend the jumper wires according to the picture above.
Note: After bend, press the jumper wires so that their height from the MIX16X circuit board's component side become 15 mm
or less.
MG166C-USB, MG166C
Connect the ten (10) jumper wires of JACK16 circuit board to the MIX16 circuit board. (MG166C-USB, MG166C)
Note: Bend the jumper wires according to the picture above.
Note: After bend, press the jumper wires so that their height from the MIX16 circuit board's component side become 15 mm
or less.
18
Connector assembly PS7P Connector assembly PS7P
Connector assembly PS5P Connector assembly PS5P
Connector assembly PS5P Connector assembly PS5P
Junper-Wire