Brother DCP-J552DW Basic User's Manual page 64

Error Message
Cannot Detect Ink
Volume
Cannot Print
Replace ink.
Cover is Open.
Data Remaining in
Memory
Document Jam/too
Long
(DCP-J752DW)
High Temperature
Hub is Unusable.
(DCP-J752DW)
56
Cause
If you are using non Brother Original
ink, the machine may not detect the
ink volume.
One or more of the ink cartridges
have reached the end of their life. The
machine will stop all print operations.
The scanner cover is not locked in the
closed position.
The ink cartridge cover is not locked
in the closed position.
Print data is left in the machine's
memory.
The document was not inserted or fed
correctly, or the document scanned
from the ADF was too long.
The room temperature is too high.
A hub or USB Flash drive with hub
has been connected to the USB direct
interface.
Action
Replace the cartridge with a Brother
Original ink cartridge. If the error
message remains, contact Brother
customer service or your local
Brother dealer.
Replace the ink cartridges. (See
Replacing the ink cartridges
on page 47.)
Lift the scanner cover, and then close
it again.
Make sure the USB cable (if used)
has been guided correctly through the
cable channel and out the back of the
machine.
Firmly close the ink cartridge cover
until it locks into place.
Press . The machine will cancel
the job and clear it from the memory.
Try to print again.
(See Using the ADF (DCP-J752DW)
on page 28.)
(See Document jam (DCP-J752DW)
on page 63.)
After lowering the room temperature,
allow the machine to cool down to
room temperature. Try again later.
Hubs, including a USB Flash drive
that have a hub built in, are not
supported. Unplug the device from
the USB direct interface.