Connecting The Wiring; Adjusting The Camera - Honeywell HD4U User Manual

Connecting the Wiring

Follow Figure 5 to connect the video and power wires.
Figure 5
Video: female BNC

Adjusting the Camera

To adjust the HD4U/X Camera:
1. Apply 12 VDC or 24 VAC power to the camera and monitor the video signal.
2. Loosen the screws that lock the gimbal assembly in place (see
3. Adjust the camera carrier to the desired view.
4. Tighten the screws to lock the gimbal assembly in place.
Note Orient the camera as shown in
Document 800-00031 Rev A
04/08
Wiring Connection
Red+
Black –
Power
Note
Figure 6 to maintain the correct picture orientation.
For secure installations,
surface-mounted cables should
be protected by plastic or metal
cable covers.
Figure 6).
13