CHARGING THE GLASSES
Connect the USB port located under the power button on the glasses to the USB port of the
TV or PC using the supplied 8-pin mini USB cable as shown by the ﬁ gure.
Do not insert the supplied 8-pin mini USB cable in the reverse direction. Otherwise, this may
cause damage to the product.
Charge the glasses until the LED is green. The glasses will fully charge in about 1 hours 50
While charging: The LED is red.
When charging is complete: The LED is green.
When the battery is discharged: The LED blinks for 1 minute and turns off automatically.
HOW TO WEAR THE 3D GLASSES
Using 3D glasses may cause minor inconveniences. If you are wearing your regular glasses, adjust the nose
pad of the 3D glasses up 90 degrees before wearing.
Q. The glasses do not work.
Q. The led LED blinks continuously.
Q. I charged the glasses with the 8-pin mini
USB cable, but it is not charged.
If you use a USB cable other the one (8-pin mini USB) supplied with the product, the
product may be damaged.
This equipment shall be powered with USB 2.0 or higher.
Please refer to the picture below for instructions. Adjust the
angle to ﬁ nd the most comfortable state for you.
A. The battery (Lithium Polymer) may be discharged, charge the battery with
the 8-pin mini USB cable.
A. Please also check the 3D settings on the TV or PROJECTOR.
A. This occurs when the battery (Lithium Polymer) is discharged. In this case,
charge the battery with the supplied 8-pin mini USB cable.
A. Check if the 8-pin mini USB cable is properly connected to the product.