Advertisement
CHARGING THE GLASSES
1
Connect the USB port located under the power button on the glasses to the USB port of the
TV or PC using the supplied 8-pin mini USB cable as shown by the fi gure.
!
▶
Do not insert the supplied 8-pin mini USB cable in the reverse direction. Otherwise, this may
CAUTION
cause damage to the product.
2
Charge the glasses until the LED is green. The glasses will fully charge in about 1 hours 50
minute
.
!
▶
NOTE
While charging: The LED is red.
▶
When charging is complete: The LED is green.
▶
When the battery is discharged: The LED blinks for 1 minute and turns off automatically.
▶
!
CAUTION
TROUBLESHOOTING
Problem.
Q. The glasses do not work.
Q. The led LED blinks continuously.
Q. I charged the glasses with the
8-pin mini USB cable, but it is
not charged.
4
The 3D glasses do not work while charging them with the USB cable.
▶
If you use a USB cable other the one (8-pin mini USB) supplied with the product, the
product may be damaged.
▶
This equipment shall be powered with USB 2.0 or higher.
A. The battery (Lithium Polymer) may be discharged, charge the
A. Check the 3D function settings of your TV.
A. This occurs when the battery (Lithium Polymer) is discharged. In
A. Check if the 8-pin mini USB cable is properly connected to the
i.e) AG-S250
Suggestion.
battery with the 8-pin mini USB cable.
this case, charge the battery with the supplied 8-pin mini USB
cable.
product.
Advertisement
