Attach The Front Wheel; Attach The Front Fender - InStep Jogging Stroller User Manual

Attach the Front Wheel

WARNING!
If the front wheel is not securely locked in place it
may fall off the Jogging Stroller and cause serious
injury or death. Always check the front wheel is
securely locked in place before use.
Position the stroller so the handle rests on the
1.
ground (front fork is now up).
To ease assembly, lock the front fork (see
2.
Page 11 for details).
Swivel
latch
4
Insert tab washer
into hole
Cone nut
washer
3. Set wheel into the forks, making sure the axle
is properly seated.
Insert the tab washer into the slot on the fork,
4.
both sides. Hand tighten the cone nut.
Close the quick release lever to the fully
5.
closed locked position. When closing the
lever it should leave an imprint on your
hand. The lever should have firm but not
excessive pressure.
6.
Pull on the wheel to ensure it is locked in
place. If necessary loosen the quick release
lever and retighten the cone nut. Re-check
the wheel.
2
3
5
Quick
Tab
release
lever

Attach the Front Fender

1. Place the front fender on the frame and over
the front wheel.
Align the mounting holes with the holes in the
2.
frame.
Insert screws (four places)
Insert the screws through the holes in the
3.
frame and tighten the front fender to the
frame. Be sure the front wheel does not rub
against the front fender.
If the front wheel wobbles or shakes, tighten the
nut that holds the fork stem to the frame. This
nut is located underneath the front fender. Do
not overtighten the nut as damage to the fork
and frame could occur or swiveling function
may cease.
Meijer.com
7