Download Print this page
InStep 11-EZ256 Operating Instructions Manual

InStep 11-EZ256 Operating Instructions Manual

Ez strider stroller single and double models

Advertisement

Quick Links

Operating Instructions for Single and Double models
Important: Read and follow these Safety Rules and Assembly Instructions before operating stroller. If you have
any questions concerning the safe use of this product, contact InSTEP , LLC at 1-800-242-6110, M-F, 8:00 a.m. –
5:00 p.m. CST or visit our web site at www.instep.net or E-mail us at info@instep.net before using.
Safety Rules:
WARNING: Failure to follow these warnings and assembly instructions could result in
serious injury or death.
WARNING: Immediately discard any plastic wrapping.
WARNING: Never allow children to fold, assemble or disassemble the stroller.
WARNING: Maximum weight capacity for the Single stroller is 50 lbs. or 22.7 kg. Double 85 lbs.
or 38.6 kg.
WARNING: Never place child in stroller on their back with their head forward and feet rearward.
WARNING: Avoid serious injury from falling or sliding out. Always use seat belt.
WARNING: Never leave child unattended.
WARNING: Never use this stroller with roller skates or in-line skates.
WARNING: Never allow stroller to be used as a toy or allow children to give rides to others.
WARNING: Never use stroller if it becomes damaged.
WARNING: Always be aware of traffic around you when walking or jogging.
WARNING: Always engage brakes when you stop or when you let go of handle.
WARNING: Always use an approved bicycle helmet on child.
WARNING: Always use wrist strap.
WARNING: Accessories or parcels placed in or on the stroller may cause it to become unstable.
WARNING: Maximum weight for objects in back pouch is 2.2 lbs. or 1 kg. Double 2.2 lbs. or 1 kg. in
each back pouch. Excessive weight may cause a hazardous, unstable condition.
WARNING: Child may slip into leg openings and strangle. Never use in a reclined carriage position
unless T-shield and shoulder strap placement has been readjusted to the seat's new
position.
Keep this manual for future reference. If you sell this stroller or
give it away, make sure you give this manual to the new owner.
Strider STROLLER
1
Ask them to read instructions completely.

Advertisement

loading

Summary of Contents for InStep 11-EZ256

  • Page 1 Important: Read and follow these Safety Rules and Assembly Instructions before operating stroller. If you have any questions concerning the safe use of this product, contact InSTEP , LLC at 1-800-242-6110, M-F, 8:00 a.m. – 5:00 p.m. CST or visit our web site at www.instep.net or E-mail us at info@instep.net before using.
  • Page 2: Parts List

    (found on the product and box) along with this instruction sheet ready when calling. If you have any questions concerning the safe use of this product, Please contact us 1-800-242-6110 press “1” for customer service and then “2 “to speak to a representative or E-mail us at info@instep.net or visit our web site at www.instep.net.
  • Page 3 IMPORTANT: The alignment of the front wheel determines if the stroller will roll straight, or pull to the right or left during use. In the event you notice the stroller pulling to one direction, loosen front axle nuts, point the front wheel in the opposite direction the stroller is pulling, ensure the tab washers are seated in the holes and tighten the nuts.
  • Page 4: Use Instructions

    WARNING: stroller before folding. Pull the seat/seats forward, locate the plastic latches on the side of the stroller frame. Using one hand on each lever, pull the levers from the lower bar.The stroller will automatically begin to fold, the front wheel will fold under frame and the handle will fold backwards ( Figure E).
  • Page 5 To engage rear brakes: Step lightly on the levers next to the rear wheels until the cogs of the brakes engage the cogs of the wheel. Repeat on other side.To release brake, lift levers using your toe until cogs disengage (Figure G).
  • Page 6: Care And Maintenance

    Loosen the front axle nuts and check to see that the tab washers are inserted in the holes of the front fork. Point the front wheel forward or in the opposite direction the stroller is pulling, then tighten the nuts with an adjustable wrench.