Before You Begin; Required Tools - Razor RipRider 360 Owner's Manual

BEFORE YOU BEGIN

Remove contents from box and check parts against part diagram below. Remove the foam separators that protect the
components from damage during shipping. Inspect the contents of the box for scratches in the paint, or dents that may
have occurred during shipping. Because the Rip Rider 360˚ was partially assembled and packed at the factory, there
should not be any problems, even if the box has a few scars or dents.
q Estimated Assembly and Set-Up Time
Razor recommends assembly by an adult with experience in bicycle mechanics.
Allow up to 15–20 minutes for assembly.
Front Fork Assembly
Front Wheel Assembly
q Required Tools
(2) 5mm
allen wrenches
(included)
Steering Bolt
Rear Caster Wheels
Pedal
10mm and 13mm
open wrenches
(included)
WARNING: DO
NOT USE NON-RAZOR
PRODUCTS WITH YOUR
RIPRIDER 360˚.
The RipRider 360˚ has been built to
certain Razor design specifications.
The original equipment supplied at
the time of sale was selected on
the basis of its compatibility with
the frame, fork and all other parts.
Certain aftermarket products may
or may not be compatible.
Seat