Samsung NC221 User Manual page 60

2
Using "PCoIP"
Touch Screen
The Touch Screen
TouchSystems
The Touch Screen
Interface.
Figure 2-23: Touch Screen
Enable right click on hold

Select this checkbox to allow users to emulate a right-click when they touch the screen and hold it
for a few seconds. If disabled, right-click is not supported.
Right click delay

Slide the pointer to a position between Long and Short to determine how long a user must touch
and hold the screen to emulate a right-click.
Touch screen calibration

When you first connect the touch screen to the zero client, the calibration program will start. On the
touch screen, touch each of the three targets as they appear.
To test the calibration, run your finger along the monitor and ensure that the cursor follows it. If it is
not successful, the calibration program automatically restarts. Once calibrated, the coordinates are
stored in flash.
To manually start the calibration program, from the OSD
onscreen prompts.
page allows you to configure and calibrate certain settings of an attached
touch screen display.
page is only available through the OSD. It is not available in the Administrative Web
Touch Screen page, click Start. Follow the
2 Using "PCoIP"
Elo
60