Samsung NC221 User Manual page 58

2
Using "PCoIP"
Display Topology
The Display Topology
a PCoIP session. To apply the
Virtual Machine (VM),
To apply the Display Topology
must have the PCoIP host software installed on the host. Refer to the "PCoIP Host Software for Windows
User Guide: TER0810001" for more details.
The Display Topology
For details about the
client, refer to the "PCoIP Host Software for Windows User Guide: TER0810001".
Always change the
>Options->User Settings interface. Do not try to change these settings using the Windows Display
Settings in a virtual machine when using
Figure 2-22: Display Topology
Enable Configuration

The device can be configured with display position, rotation and resolution settings if enabled. The
settings are saved when you click
Display Layout

Select whether you want a horizontal or vertical layout for your displays (A and B). This setting should
reflect the physical layout of the displays on your desk.
Horizontal

Vertical

page allows users to change the position, rotation, and resolution of a display for
Display Topology
VMware View 4.5 or later is required.
feature to a PCoIP session between a zero client and a PCoIP host, you
tab has no corresponding menu in the Administration Web Interface.
Display Topology
Display Topology settings using the
Apply
: Select to arrange A and B horizontally, with A located to the left of B.
: Select to arrange A and B vertically, with A located above B.
feature to a PCoIP session between a zero client and a
feature for a PCoIP session between a host card and a zero
Display Topology
VMware View.
or OK and are applied when the device is reset.
tab on the zero client OSD-
58
2 Using "PCoIP"