Adding A Camera Title Display - Honeywell HCS544 User Manual

Adding a Camera Title Display

To add a camera title:
1. On the SPECIAL menu, select CAMERA ID and then
press ENTER
Figure 7
2. Press the menu control UP, DOWN, LEFT, or RIGHT to
select a character, then press ENTER (SET) to accept
it. The character is saved and the title cursor at the
bottom of the screen moves to the next position. You
can use the
title name to make changes, and you can also select
CLR to delete the entire title and start again.
3. Repeat
4. Select POS to position where you would like the
camera title to be located on screen. Select the position
using the menu control, then press ENTER (SET) to
confirm the position.
5. Select END when you are finished.
16
SET).
(
Adding Camera Title
CAMERA ID
A B C D E F G H I J K L M
N O P R Q S T U V W X Y Z
a b c d e f g h i j k l m
n o p q r s t u v w x y z
– . 0 1 2 3 4 5 6 7 8 9
& ' CLR POS END
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _
symbols to go back or forward in the
& '
step 2 until your camera title is complete.