Motorola Symbol LS4208 Product Reference Manual page 101

To set up the scanner:
NOTE Interface cables vary depending on configuration. The connectors illustrated in
only. The connectors may be different than those illustrated, but the steps to connect the scanner are the
same.
Attach the modular connector of the USB interface cable to the cable interface port on the scanner (see
1.
Installing the Interface Cable on page
Plug the series A connector in the USB host or hub, or plug the Plus Power connector in an available port of
2.
the IBM SurePOS terminal.
Select the USB device type by scanning the appropriate bar code from
3.
On first installation when using Windows, the software prompts to select or install the Human Interface Device
4.
driver. To install this driver, provided by Windows, click Next through all the choices and click Finished on the
last choice. The scanner powers up during this installation.
To modify any other parameter options, scan the appropriate bar codes in this chapter.
5.
If problems occur with the system, see
1-3).
Troubleshooting on page 3-2.
USB Interface
Figure 7-1 are examples
USB Device Type on page
7 - 3
7-5.