Removing The Interface Cable; Connecting A Synapse Cable Interface; Connecting Power (If Required) - Motorola Symbol LS4208 Product Reference Manual

1 - 4 Symbol LS4208 Product Reference Guide

Removing the Interface Cable

To remove the interface cable:
Unplug the installed cable's modular connector by depressing the connector clip with the tip of a screwdriver.
1.
Carefully slide out the cable.
2.
Follow the steps for
3.

Connecting a Synapse Cable Interface

NOTE Refer to the Synapse Interface Guide provided with the Synapse cable for detailed setup instructions.
Symbol's Synapse Smart Cables enable interfacing to a variety of hosts. The appropriate Synapse cable has the
built-in intelligence to detect the host to which it is connected.
To host
Synapse Smart Cable
Synapse Cable Connection
Figure 1-3
Plug the Synapse adapter cable (p/n
1.
Interface Cable on page
Align the 'S' on the Synapse adapter cable with the 'S' on the Synapse Smart Cable and plug the cable in.
2.
Connect the other end of the Synapse Smart Cable to the host.
3.

Connecting Power (if required)

If the host does not provide power to the scanner, an external power connection to the scanner is required. To
connect power:
Connect the interface cable to the bottom of the scanner, as described in
1.
1-3.
Connect the other end of the interface cable to the host (refer to the host manual to locate the correct port).
2.
Plug the power supply into the power jack on the interface cable. Plug the other end of the power supply into
3.
an AC outlet.
Installing the Interface Cable on page 1-3
25-32463-xx)
1-3.
to connect a new cable.
Synapse Adapter Cable
To Scanner
into the bottom of the scanner, as described in
Installing the Interface Cable on page
Installing the