Hardware Setup - Kanguru Defender KDH3B User Manual

2.2 Hardware Setup

Follow these instructions to connect the Defender drive to your computer:
1. Remove the USB cable from the side of the Defender. The easiest way to release the cable is by
pulling out the USB A side first, as shown in the image below.
2. On the other side of the drive, pull open the rubber USB cover to reveal the USB port.
3. Connect the Micro B side of the USB cable to the Defender's USB port. Connect the A side of the
USB cable to your computer. The LED indicators on the side of the drive will light up. You are now
ready to begin using your Kanguru Defender drive.
↓
USB Micro-B
USB A
↓
to computer
8
↓
to drive
Hardware Setup