Sanyo PLC-XF35 Service Manual page 7

Lamp Replacement
CAUTION
For continued safety, replace with a lamp
assembly of same type.
Allow a projector to cool for at least 45
minutes before you open Lamp Cover. Inside
of a projector can become very hot.
Follow these steps to replace lamp assembly.
1
Check number of lamp to be replaced on Lamp Status Display.
2
Turn off a projector and disconnect AC Power Cord. Allow a
projector to cool for at least 45 minutes.
3
Loosen 3 screws on Lamp Cover and remove Lamp Cover.
(See right figure.)
4
Loosen 2 screws and pull out Lamp Assembly to be replaced
by grasping handle.
5
Replace Lamp Assembly with a new one and tighten 2 screws.
Make sure that Lamp Assembly is set properly
6
Replace Lamp Cover and tighten 3 screws.
7
Connect AC Power Cord to a projector and turn projector on.
8
Reset Lamp Replacement Counter. (Refer to section "Lamp
Counter Reset".)
NOTE : Do not reset LAMP REPLACEMENT COUNTER
when lamp is not replaced.
CAUTION : DO NOT OPERATE A PROJECTOR WHILE ANY OF LAMPS IS REMOVED. IT MAY
RESULT IN MALFUNCTIONS, FIRE HAZARD, OR OTHER ACCIDENTS.
NOTES ON LAMP REPLACEMENT
To maintain quality of picture (better balance of color and brightness in entire screen), we recommend replacing
all 2 lamps at a time.
ORDER REPLACEMENT LAMP
G Replacement Lamp Type No.
Lamp Service Parts No.
CAUTION
Do not drop a lamp assembly or touch a glass
bulb! Glass can shatter and may cause injury.
LAMP
COVER
SCREWS
Make sure which number of lamp needs to be
replaced on Lamp Status Display.
Figure shows case of replacing LAMP 2.
: POA-LMP52
: 610 301 6047
-7-
SCREWS
LAMP 1
LAMP 2