Aiwa VX-G142 Service Manual page 10

1
Audio Control Head
Spring
Audio Control Head Base
2-11: CYLINDER UNIT (Refer to Fig. 2-11)
1. Disconnect the following connectors: (CP4101 and CP4102)
on the Head Amp PCB.
2. Remove the Joint Screw, then remove the Azimuth Spring.
Remove the 2 screws 1, then remove the Polyslider
3.
Washer and Cylinder Unit from the Main Chassis.
1
2-12: PLATE BOTTOM (Refer to Fig. 2-12)
1. Remove the Capstan Belt.
2. Remove the 2 screws 1.
3. Remove the 3 screws 2.
4. Remove the Mode Switch.
5. Remove the Tension Lever Spring.
6. Remove the Plate Bottom.
NOTE
When installing the Mode Switch, align the timing position.
DISASSEMBLY INSTRUCTIONS
1
1
Audio Control Head
Audio Control Head
Spring
Fig. 2-10
Cylinder Unit
Polyslider Washer
Main Chassis
Azimuth Spring
1
Joint Screw
Fig. 2-11
Mode Switch
Tension Lever
Spring
Marker
2-13: CENTER PULLEY (Refer to Fig. 2-13)
1. Remove the Polyslider Washer 1.
2. Remove the Center Pulley.
3. Remove the Polyslider Washer 2.
4. Remove the Center Pulley Spring.
5. Remove the Idler Arm Ass'y.
6. Remove the 2 Polyslider Washers 3.
7. Remove the Clutch Gear T Ass'y and Clutch Gear S Ass'y.
Polyslider Washer
Polyslider Washer
Clutch Gear S Ass'y
B2-4
2
2
2
1
1
Deck Chassis
Position
Polyslider Washer
Center Pulley
2
Center Pulley Spring
Idler Arm Ass'y
3
Polyslider Washer
Clutch Gear T Ass'y
Capstan Belt
Plate Bottom
Fig. 2-12
1
3
Fig. 2-13