ZyXEL Communications P-2601HN-F1 Series Quick Start Manual page 5

5. POWER: Use the power adaptor provided to connect an appropriate
power source to this socket.
6. Push the power button to the ON position.
Look at the LEDs (lights) on the top panel of the P-2601HN(L)-F1 Series.
• The WIRELESS light stays green when the wireless LAN is ready. It
blinks when the P-2601HN(L)-F1 Series is sending/receiving data
through the wireless LAN.
• The POWER light blinks during start-up and is green once the P-
2601HN(L)-F1 Series is ready.
• The ETHERNET light turns on if the corresponding ETHERNET
port is properly connected. If you do not connect a computer
correctly to this port, the ETHERNET light will not turn on.
The ETHERNET and/or WIRELESS lights blink when the P-2601HN(L)-
F1 Series is sending or receiving data. If the POWER light does not turn
on during start up, try turning the P-2601HN(L)-F1 Series off, check the
connections, wait a few seconds and then turn it back on. If the problem
persists, you may have a hardware problem and you need to contact
your vendor.
• The PHONE light stays on when your SIP account is registered and
blinks if the receiver is off the hook. See
page 9 to see how to make calls through the Internet.
The Web Configurator on
5