Connections - Radio Shack CDG Karaoke System Owner's Manual

%100'%6+105
% "/
100'%6+0) +%412*10'5
The system has two microphone jacks,
Use the supplied microphone to sing along with your
favorite recordings, and connect an optional microphone
(not supplied) for duets or lead and background vocals. For
the best performance, the additional microphone should be
a unidirectional 600-ohm dynamic microphone with a
1 / -inch (6.35-mm) plug and an ON/OFF switch. Your local
4
RadioShack store has a wide selection of microphones.
1. Set
MASTER VOLUME
2. If you are connecting only one microphone, plug it into
.
MIC 1
If you are connecting a second microphone, plug it into
.
MIC 2
3. To store the microphone, pull down the built-in
microphone holder and place the microphone in the
holder's grip.
When a microphone is plugged into
system mixes the microphone output with recorded music
from cassette tapes, CDs, or CDGs.
% "
100'%6+0) #0
# "%
7&+1 1/210'06
To sing along with music from an optional component (such
as a tuner, A/V receiver, or VCR), connect the component's
audio output jacks to the system's
To hear your voice and music from the system through an
optional component (such as equalizer/booster or PA
system), connect the component's audio input jacks to the
system's and
AUX OUT R
% "
100'%6+0) #0
8 "%
+&'1 1/210'06
To see images on the karaoke screen from an optional
video component (such as a VCR or DVD player), plug one
end of the supplied cable into
into the video component's video output jack.
and
MIC 1
to .
MIN
or
MIC 1 MIC 2
"1 "
26+10#.
and
AUX IN R L
jacks.
L
"1 "
26+10#.
and the other end
VIDEO IN
R
"9#40+0)"
To avoid electrical shock, do not
connect the system to AC power
until all other connections are
.
MIC 2
complete.
R R R R ý
, the
jacks.
R
"
9