Advertisement
I n s t a l l
the plow on the tractor: Secure the
1.
link pins to the lower
pins. Install the hitch upper link at the top
hole in the mast and secure with the hitch
2.
Working on flat ground,
-
of the tractor
position-right tractor tires in furrow
left tires on land.)
and lower the plow with the
3 . Raise
hydraulic lift; the plow bottom should
contact the ground with the lift lever in
the lowered or "float" position.
Next, raise the plow slightly
and adjust the upper and lower
the plow bottom
completely level with
is
the ground. Place! the hitch in the float
position and check the plow bottom:
should rest cornpletelyflat on the ground.
links
with spring
the left side
raise
and block at this
a
plowing
wall,
off the ground
links so
it
Finally, adjust the upper link slightly so
the landside heel
is
the ground.
Align the plow directly behind the tractor
4.
(upper link extended straight toward rear).
With a straightedge
extend a line from the inside edge of the
right rear tire on back to the plow bottom.
simulates a furrow
(This
plow to cut
wide (standard width). the.
bottom should reach this line.
To increase or decrease the standard
cutting width,
see
PLOW ADJUSTMENTS
on the next page.
5.
Set the gauge wheel approximately 5"
above the ground. This will provide a
controlled 6" plow depth and prevent the
plow from going too deep in soft and/or
wet spots.
approximately
off
steel bar, etc.),
(2
x
4,
For the
Advertisement
