Skid Shoes And Scraper - Honda HS624 Owner's Manual

SERVICING YOUR HONDA SNOWBLOWER
SKID SHOES AND SCRAPER
Turn the engine switch to the OFF position, and disconnect the spark plug cap,
so the engine cannot be accidentally started while you are near the auger.
Inspection
1. Raise the auger housing off the
ground.
Track type: Step on the foot pedal
(page1 4), and raise the auger to
the highest position.
Wheel type: Place a block of
wood under the scraper to
support the auger.
2. Measure the thicknessof the right
and left skid shoes at their
thinnest point.
Replace the skid shoes if they
are worn to the specified service
limit.
A=NEW thickness
B=WORN thickness
SKID SHOE SERVICE LIMIT
Rear-mount type
1/16 in (1.5mm)
Side-mount type
3/32 in (2.5mm)
50