Table of Contents
Advertisement
Installing additional video boards
The multi-function controller comes with four slots for
installing additional video boards.
By adding the AW-PB605 video boards (optional
accessory), up to five pan-tilt head systems can be
controlled.
Before installing additional video boards, set the
power switches of the components to the OFF
position, and disconnect the power cords from the
power outlets.
1. Remove the two screws and take off the blank panel.
2. Align the AW-PB605 video board (optional accessory)
with the guides, and insert it. Push it in all the way.
3. Attach the board securely using the two screws.
Inserting an optional card
The multi-function controller comes with a slot into which an
optional card (optional accessory) for additional functions
can be inserted.
ORGB card (AW-PB302)
OSDI card (AW-PB304)
OSVGA convert card (AW-PB307)
OWeb card (AW-PB309)
The same cards can also be inserted for the AW-PB605
video boards (optional accessory).
Before installing the optional card, set the power
switches of the components to the OFF position, and
disconnect the power cords from the power outlets.
1. Remove the two screws, followed by the blank panel.
2. Align the optional card with the guides and insert it. Push
it in all the way.
3. Attach the card securely using the two screws.
To remove the optional card, insert a flat-head screwdriver
or similar tool as shown in the figure on the right, and pull
out the card in the direction shown by the arrow.
Slots for installing
additional video boards
Slot for optional card
41
Advertisement
Table of Contents
