Using Your Refrigerator; Setting The Controls; Ensuring Proper Air Circulation - Kenmore MFL37933584 Use & Care Manual

SETTING THE CONTROLS

Temperature
• Your refrigerator has a control pad on the dispenser that
lets you regulate the temperature in the freezer and
refrigerator compartments.
• Initially set the refrigerator control at 37°F (3°C) and the
freezer control at 0°F (–18°C). Leave it at these settings
for 24 hours (one day) to stabilize. Then adjust the
compartment temperature as desired.
• Refrigerator Temp Control: 33°F to 46°F (0°C to 8°C)
The lower the number setting, the colder the refrigerator
compartment will become.
• Freezer Temp Control: -6°F to 8°F (-21°C to -13°C)
When the setting is at a lower number, the freezer
compartment becomes colder. The refrigerator
compartment becomes warmer because less cold air
flows into the refrigerator.
UltraIce
• When you touch the UltraIce button, the graphic
[ ] will light up in the display and it continues for
24 hours. It will automatically shut off after 24 hours
have passed. Or you can stop this function manually by
touching the button one more time.
• This function increases both icemaking and freezing
capabilities.
Dispenser
• You can select water, crushed ice, or cubed
ice by touching button as you desire.
• There could be some dripping after
dispensing.
• Hold your cup below the dispenser after
dispensing to catch all drops.
w w CAUTION: The control display is operated
by touch. Excessive moisture on the
display may cause a malfunction. Please
keep display clean and dry.
w w WARNING: If a door is open, the dispenser does not
work.

USING YOUR REFRIGERATOR

16
Filter
• Filter Reset : When the FILTER RESET indicator light turns
on, you have to change the water filter. Press the FILTER
RESET button for 3 seconds to turn the indicator light off. You
need to change the water filter approximately every 6 months.
Light / Light Sensor
• If the light is set "Auto" mode, dispenser light will
automatically turn on and off according to the brightness of
room detected by light sensor.
Alarm
• When the power is connected to the refrigerator, door alarm
is initially set off and door alarm display will show
When you touch button, the display will change to
and door alram function is now activated.
• When either refrigerator or the freezer door is left open for
more than 60 seconds, the alarm will ding to let you know
the door is open.
• When you close the door, the door alarm will stop dinging.
• If you want to disable the door alarm function, touch
button then the door alarm display will switched to
Lock
• When the power is initially connected to the refrigerator,
Lock function is off.
• If you want to activate Lock function to lock other buttons,
press and hold button for 3 seconds or more.
will be displayed and the Lock function is now enabled.
• No buttons other than
dispenser button while Lock function is enabled.
• To disable the Lock function, press and hold
3 seconds or more.
Temperature Mode Switch Function(°F <->°C)
• If you want to convert °F to °C or vice versa, press and hold
button and button simultaneously for 5 seconds
or more.
w w CAUTION
Display mode setting and its cancellation
1. With the refrigerator door open, keep pressing the
Refrigerator Temp Button and UltraIce Button more than
5 seconds, then it goes to the display mode with Special
Beep Sound with special beep sound.
2. Perform the same way again to cancel the display mode.
3. All freezing unit will be turned off at display mode
(Exceptions: Lamp, Display)

ENSURING PROPER AIR CIRCULATION

Do not block air channels with any objects or food for air
circulation to prevent food loss due to the lack of cooling air.
button will work even including
button for
.
.
sign