Honda GENERATOR EB3800X Owner's Manual page 67

Wheel Kit Installation
1. Apply grease to the axle shaft as shown below, and install the two
wheels on the axle shaft using the washers and split pins.
2. Install the axle assembly on the generator using four 8
flange bolts and 8 mm flange nuts.
3. Install the two stands on the under frame using four 8
flange bolts.
TORQUE: 17 22 lbf·ft (24 29 N·m , 2.4 3.0 kgf·m) −
8 16 mm FLANGE BOLT (4) ×
20 mm WASHER (2)
STAND (2)
− −
AXLE
8 mm FLANGE NUT (4)
LONGER
8 16 mm FLANGE BOLT (4) ×
WHEEL (2)
4.0 30 mm
COTTER PIN (2)
× 16 mm
× 16 mm
GENERATOR
SIDE
×
65