Table of Contents
Advertisement
Starting the Software
1. Run the program by opening the program named "Flow
Anemometer".
Flow Anemometer is in the programs folder of your
Windows software.
2. Wait for the program to initialize and select COM 1 or 2
as required.
The program will load and the main display will appear.
A red NO COM icon will flash on the bottom right hand
side of the display.
3. Press and hold
pressing
The RS232 icon will appear on the upper right hand side
display of the meter.
The NO COM icon will disappear.
Communications has been established.
Values will appear in the diplay.
then power on the meter by
Model 451126 Version 1.6 February 2004
8
Advertisement
Table of Contents
Need help?
Do you have a question about the 451126 and is the answer not in the manual?
Questions and answers