Ac Operation - Honda EM650 Owner's Manual

AC Operation
1. Start the engine (refer to page 23) and make sure the pilot lamp comes on.
If not, the filament may be burnt out.
2. Plug in the appliance.
1 NOTICE ( Substantial overloading will switch off the circuit protector.
Marginal overloading may not switch off the circuit protector, but it will
shorten the service life of the generator.
Be sure that all appliances are in good working order before connecting
them to the generator. If an appliance begins to operate abnormally,
becomes sluggish, or stops suddenly, turn off the generator engine
switch immediately. Then disconnect the appliance and examine it for
signs of malfunction.
NOTE: If an overloaded circuit trips the AC circuit protector, reduce the
electrical load on the circuit, and wait a few minutes before resuming
operation.
The green indicator inside the circuit protector button will pop out to show that
the circuit protector has switched off.
Push the button in to reset the circuit protector.
PILOT LAMP
AC CIRCUIT BREAKER
AC RECLPTACLES
16