Kenwood DNX7210BT Quick Start Manual page 11

Number Name
fi (Reset)
1
MENU
2
NAV
3
TEL
4
Volume Knob • Pressing switches attenuation of the volume on/off.
5
SCRN
6
Remote
7
Sensor
0 (Eject)
8
Disc insert
9
slot
10
Input jack
11
Release key
SD card slot
12
SI indicator
13
* T he display may not switch to the Tone Control screen in some conditions.
• If the unit or the connected unit fails to operate properly, the unit returns
to factory settings when this button is pressed (Instruction Manual
P.99).
• If the SI function is turned on, this indicator flashes when the vehicle
ignition is off (Instruction Manual P.72).
• Displays the Top Menu screen (Instruction Manual P.17).
• Pressing for 1 second turns the power off.
• When the power off, turns the power on.
• Displays the navigation screen.
• Pressing for 1 second switches AV out sources.
• Displays the Hands Free screen (Instruction Manual P.54).
• Pressing for 1 second turns off the display.
• Turning adjusts volume up or down.
• Pressing for 1 second displays Tone Control screen (Instruction Manual
P.87).*
• Displays the Screen Control screen.
• Pressing for 1 second displays rear view camera display.
• Receives the remote control signal.
• You can enable or disable this feature by Remote Sensor (Instruction
Manual P.70).
• If [Remote Sensor] is set to off, the remote control of TV reception is
rejected.
• Ejects the disc.
• Pressing for 1 second ejects the disc forcibly.
A slot to insert a disc media.
An input jack for external device.
Detaches the front panel.
A slot to insert an SD card. The card is used for upgrading the map. For
how to upgrade the map, refer to the instruction manual of the navigation
system.
For DNX5210BT, you can play audio/visual file in the card.
If the SI function is turned on, this indicator flashes when the
vehicle ignition is off (Instruction Manual P.72).
11
DNX7210BT/DNX5210BT/DNX5510BT/DNX4210BT
Motion