Table of Contents
Advertisement
Antenna Installation
The antenna included with your Husky is safely stored in a slot underneath the
control panel. To remove the antenna, pull out the plastic retainer cap located at
the front of your Husky transmitter, then slide the antenna out. Insert the base of
the antenna into the antenna receptacle at the top of the control panel. Then screw
the antenna clockwise until it is firmly attached. Be careful not to over tighten the
antenna.
NOTE The antenna should be fully extended while transmitting. Otherwise the operating
range of the system will be reduced, causing a loss of control.
Loading the batteries
Your Husky transmitter requires 8 AA batteries (not included). Alkaline batteries
will provide power for approximately 7 hours of use. The battery compartment is
located at the bottom of the transmitter body.
1. Make sure the Power switch is set to OFF position.
2. Release the hook and the battery cover will pop up.
3. Pull out the battery holder slowly and carefully unplug the connector from the
battery compartment. Install 8 AA batteries into the battery holder.
4. Insert the connector back in and place the battery holder back into the battery
compartment. Press down the battery cover until it locks in place tightly.
8
Preparation
Advertisement
Table of Contents
