Chapter 4
Data Setting & Programming - Husky Transmitter
There are 3 modes (System, Pit, and Circuit) of setup fields and 3 levels (Basic,
Intermediate, Advanced ) of programming under the Circuit Mode. This chapter explains
how individual parameter can be adjusted.
Names of Parts on Control Panel
Trim button
LCD Display
When the power switch is set to ON or Standby (S/B) the normal LCD display shows
as illustrated below. The STB, D/R, STA, IDL, ABS and / or SST are displayed only
when such functions are programmed or activated.
Channel # / Frequency
Model # & Name / Stopwatch
NOTE Actual display on your Husky may appear slightly different than above,
depending on the product's region, frequency band or the software version installed.
antenna receptacle
LCD
steering wheel
Level
ADV
50 : FM 40.665 MHz
Shift
SHIFT : POSITIVE
1 : ALL
STB
D/R
STA
Standby
Dual rate
Start
Data Setting & Programming
Power level
10.3 V
IDL
ABS
SST
Steering Speed based on Throttle
Anti-lock braking system
Idle up
14
mode button
enter/stopwatch button
down / idle up button
up / start button
+,- / dual rate button